HP JD320B User Manual

Configuration prerequisites
Voice tests require cooperation between the NQA server and the NQA client. Before you start voice tests,
configure a UDP listening service on the NQA server. For more information about UDP listening service
configuration, see “Configuring the NQA server.”
Configuring voice tests
Follow these steps to configure voice tests:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as voice,
and enter test type view
type voice Required
Configure the destination address
of voice probe packets
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address must be
the same as that of the listening
service on the NQA server.
Configure the destination port of
voice probe packets
destination port port-number
Required
By default, no destination port
number is configured.
The destination port must be the
same as that of the listening service
on the NQA server.
Configure the codec type
codec-type { g711a | g711u |
g729a }
Optional
By default, the codec type is
G.711 A-law.
Configure the advantage factor for
calculating MOS and ICPIF values
advantage-factor factor
Optional
By default, the advantage factor is
0.
Specify the source IP address of
probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Specify the source port number of
probe packets
source port port-number
Optional
By default, no source port number
is specified.
23

HP JD320B Specifications

General

Brand	HP
Model	JD320B
Category	Switch
Language	English