HP JD320B User Manual

To do… Use the command… Remarks
Enter VLAN interface view
interface interface-type
interface-number
Enter the interface used to send
NTP multicast message.
Configure the device to work in
NTP multicast server mode
ntp-service multicast-server
[ ip-address ]
[ authentication-keyid keyid | ttl
ttl-number | version number ] *
Required
NOTE:
• A multicast server can synchronize broadcast clients only when its clock has been synchronized.
• You can configure up to 1024 multicast clients, among which 128 can take effect at the same time.
Configuring optional parameters of NTP
Specifying the source interface for NTP messages
If you specify the source interface for NTP messages, the device sets the source IP address of the NTP
messages as the primary IP address of the specified interface when sending the NTP messages.
When the device responds to an NTP request received, the source IP address of the NTP response is
always the IP address of the interface that received the NTP request.
Following these steps to specify the source interface for NTP messages:
To do… Use the command… Remarks
Enter system view system-view —
Specify the source interface for
NTP messages
ntp-service source-interface
interface-type interface-number
Required
By default, no source interface is
specified for NTP messages, and
the system uses the IP address of
the interface determined by the
matching route as the source IP
address of NTP messages.
CAUTION:
• If you have specified the source interface for NTP messages in the ntp-service unicast-server or
ntp-service unicast-peer command, the interface specified in the ntp-service unicast-server or
ntp-service unicast-peer command serves as the source interface of NTP messages.
• If you have configured the ntp-service broadcast-server or ntp-service multicast-server command, the
source interface of the broadcast or multicast NTP messages is the interface configured with the
respective command.
• If the specified source interface for NTP messa
g
es is down, the source IP address for an NTP messa
g
e
that is sent out is the primary IP address of the outgoing interface of the NTP message.
Disabling an interface from receiving NTP messages
When NTP is enabled, NTP messages can be received from all the interfaces by default.
57

HP JD320B Specifications

General

Brand	HP
Model	JD320B
Category	Switch
Language	English