EasyManuals Logo
Home>HP>Switch>JD320B

HP JD320B User Manual

HP JD320B
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
[SwitchB-Vlan-interface3] igmp enable
[SwitchB-Vlan-interface3] igmp static-group 224.0.1.1
[SwitchB-Vlan-interface3] quit
[SwitchB] interface ethernet 1/0/1
[SwitchB-Ethernet1/0/1] igmp-snooping static-group 224.0.1.1 vlan 3
5. Configure Switch A:
<SwitchA> system-view
[SwitchA] interface vlan-interface 3
# Configure Switch A to work in multicast client mode and receive multicast messages on VLAN-interface
3.
[SwitchA-Vlan-interface3] ntp-service multicast-client
# View the NTP status of Switch A after clock synchronization.
[SwitchA-Vlan-interface3] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 40.00 ms
Root dispersion: 10.83 ms
Peer dispersion: 34.30 ms
Reference time: 16:02:49.713 UTC Sep 19 2005 (C6D95F6F.B6872B02)
The output shows that Switch A has been synchronized to Switch C, and the clock stratum level of Switch
A is 3, while that of Switch C is 2.
# View the NTP session information of Switch A, which shows that an association has been set up
between Switch A and Switch C.
[SwitchA-Vlan-interface3] display ntp-service sessions
source reference stra reach poll now offset delay disper
**************************************************************************
[1234] 3.0.1.31 127.127.1.0 2 255 64 26 -16.0 40.0 16.6
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
Configuring NTP client/server mode with authentication
Network requirements
As shown in Figure 27, perform the following configurations to synchronize the time between Device B
and Device A and ensure network security as follows:
The local clock of Device A is to be configured as a reference source, with the stratum level of 2.
Device B works in client mode and Device A is to be used as the NTP server of Device B, with Device
B as the client.
NTP authentication is to be enabled on both Device A and Device B.
68

Table of Contents

Other manuals for HP JD320B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP JD320B and is the answer not in the manual?

HP JD320B Specifications

General IconGeneral
BrandHP
ModelJD320B
CategorySwitch
LanguageEnglish

Related product manuals