HP MSR4080 Configuration Guide

117
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter PIM view.
pim
[
vpn-instance
vpn-instance-name ]
N/A
3. D
isable the device from
sending BSMs out of
incoming interfaces.
undo bsm-reflection enable
By default, the device is enabled
to forward BSMs out of incoming
interfaces.
Configuring PIM-SSM
PIM-SSM requires IGMPv3 support. Enable IGMPv3 on PIM routers that connect to multicast
receivers.
PIM-SSM configuration task list
Tasks at a glance
(Required.) Enabling PIM-SM
(Optional.) Configuring the SSM group range
(Optional.) Configuring common PIM features
Configuration prerequisites
Before you configure PIM-SSM, configure a unicast routing protocol so that all devices in the domain
can interoperate at the network layer.
Enabling PIM-SM
Before you configure PIM-SSM, you must enable PIM-SM, because the implementation of the SSM
model is based on subsets of PIM-SM.
When you deploy a PIM-SSM domain, enable PIM-SM on non-border interfaces of the routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same PIM mode.
To enable PIM-SM:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2.
Enable IP multicast routing,
and enter MRIB view.
multicast routing
[
vpn-instance
vpn-instance-name ]
By default, IP multicast routing is
disabled.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
interface-number
N/A
5. Enable PIM-SM.
pim sm
By default, PIM-SM is disabled.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English