HP MSR4080 Configuration Guide

360
Step
Command
Remarks
2. Enter IPv6 PIM view.
ipv6 pim
[
vpn-instance
vpn-instance-name ]
N/A
3. Set the hello interval.
timer hello
interval
By default, the interval to send
hello messages is 30 seconds.
4. Set the join/prune interval.
timer join-prune
interval
By default, the interval to send
join/prune messages
is 60
seconds.
NOTE:
This configuration takes effect
after the current interval ends.
5.
Set the joined/pruned state
holdtime.
holdtime join-prune
time
By default, the joined/pruned
state holdtime timer is 210
seconds.
6.
Set the IPv6 multicast
source lifetime.
source-lifetime
time
By default, the IPv6 multicast
source lifetime is 210 seconds.
Configuring common IPv6 PIM timers on an interface
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set the hello interval.
ipv6 pim timer hello
interval
The default setting is 30 seconds.
4. Set the triggered hello delay.
ipv6 pim triggered-hello-delay
delay
The default setting is 5 seconds.
5. Set the join/prune interval.
ipv6 pim timer join-prune
interval
The default setting is 60 seconds.
This configuration takes effect
after the current interval ends.
6.
Set the joined/pruned state
holdtime.
ipv6 pim holdtime join-prune
time
The default setting is 210
seconds.
Setting the maximum size of each join or prune message
The loss of an oversized join or prune message might result in loss of massive information. You can
set a small value for the size of each join or prune message to reduce the impact.
To set the maximum size of each join or prune message:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 PIM view.
ipv6 pim
[
vpn-instance
vpn-instance-name ]
N/A
3.
Set the maximum size of
each join or prune message.
jp-pkt-size
size
The default setting is 8100 bytes.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English