HP MSR4080 Configuration Guide

71
IGMP configuration task list
Tasks at a glance
Configuring basic IGMP features:
• (Required.) Enabling IGMP
• (Optional.) Specifying an IGMP version
• (Optional.) Configuring a static group member
• (Optional.) Configuring a multicast group policy
Adjusting IGMP performance:
(Optional.) Configuring IGMP query and response parameters
(Optional.) Enabling fast-leave processing
(Optional.) Configuring IGMP SSM mappings
Configuring IGMP proxying:
• (Optional.) Enabling IGMP proxying
• (Optional.) Enabling multicast forwarding on a non-querier interface
• (Optional.) Configuring multicast load splitting on an IGMP proxy
(Optional.) Enabling IGMP NSR
Configuring basic IGMP features
Before you configure basic IGMP features, complete the following tasks:
•
Configure any unicast routing protocol so that all devices can interoperate at the network layer.
•
Configure PIM.
•
Determine the IGMP version.
•
Determine the multicast group and multicast source addresses for static group member
configuration.
•
Determine the ACL to be used in the multicast group policy.
Enabling IGMP
Enable IGMP on the interface where the multicast group memberships are established and
maintained.
To enable IGMP:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enable IP multicast routing
and enter MRIB view.
multicast routing
[
vpn-instance
vpn-instance-name ]
By default, IP multicast routing is
disabled.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
interface-number
N/A
5. Enable IGMP.
igmp enable
By default, IGMP is disabled.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English