HP MSR4080 Configuration Guide

122
Step
Command
Remarks
4. Set the join/prune interval.
timer join-prune
interval
The default setting is 60 seconds.
This
configuration takes effect
after the current interval ends.
5.
Set the joined/pruned state
holdtime.
holdtime join-prune
time
The default setting is 210
seconds.
6.
Set the multicast source
lifetime.
source-lifetime
time
The default setting is 210
seconds.
Configuring common PIM timers on an interface
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set the hello interval.
pim timer hello
interval
The default setting is 30 seconds.
4. Set the triggered hello delay.
pim triggered-hello-delay
delay
The default setting is 5 seconds.
5. Set the join/prune interval.
pim timer join-prune
interval
The default setting is 60 seconds.
This configuration takes effect
after the current interval ends.
6.
Set the joined/pruned state
holdtime.
pim holdtime join-prune
time
The default setting is 210
seconds.
Setting the maximum size of each join or prune message
The loss of an oversized join or prune message might result in loss of massive information. You can
set a small value for the size of each join or prune message to reduce the impact.
To set the maximum size of each join or prune message:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter PIM view.
pim
[
vpn-instance
vpn-instance-name ]
N/A
3. Set the
maximum size of
each join or prune message.
jp-pkt-size
size
The default setting is 8100 bytes.
Enabling BFD for PIM
If a DR on a shared-media network fails, a new DR election process does not start until the DR ages
out. In addition, it might take a long period of time before other routers detect the link failures and
trigger a new DR election. To start a new DR election process immediately after the original DR fails,
enable BFD for PIM to detect link failures among PIM neighbors.
You must enable BFD for PIM on all PIM routers on a shared-media network. For more information
about BFD, see High Availability Configuration Guide.
You must enable PIM-DM or PIM-SM on an interface before you configure this feature on the
interface.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English