290
You do not need to enable IPv6 multicast routing before this configuration.
To configure IPv6 multicast load splitting:
1. Enter system view.
system-view
N/A
2. Enter IPv6 MRIB view.
[
vpn-instance
vpn-instance-name ]
N/A
3.
load splitting.
load-splitting
{
source
|
source-group
}
By default, IPv6 multicast load
splitting is disabled.
This command does not take
effect on IPv6 BIDIR-PIM.
Configuring an IPv6 multicast forwarding boundary
You can configure an interface as an IPv6 multicast forwarding boundary for an IPv6 multicast group
range. The interface cannot receive or forward IPv6 multicast packets for the groups in the range.
TIP:
You do not need to enable IPv6 multicast routing before this configuration.
To configure an IPv6 multicast forwarding boundary:
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure an IPv6 multicast
forwarding boundary.
ipv6 multicast boundary
{
ipv6-group-address prefix-length
|
scope
{ scope-id |
admin-local
|
global
|
organization-local
|
site-local
} }
By default, an interface is not an
IPv6 multicast forwarding
boundary for any IPv6 multicast
groups.
Configuring static IPv6 multicast MAC address entries
In Layer-2 multicast, a Layer-2 IPv6 multicast protocol (such as MLD snooping) can dynamically add
IPv6 multicast MAC address entries. Or, you can manually configure IPv6 multicast MAC address
entries.
TIP:
•
You do not need to enable IPv6 multicast routing before this configuration.
• The IPv6 multicast MAC address that can be configured in the MAC address entry must be unused. An
IPv6 multicast MAC address is the MAC address in which the least significant bit of the most significant
You can configure static IPv6 multicast MAC address entries on the specified interface in system
view, or on the current interface in interface view.
To configure a static IPv6 multicast MAC address entry in system view:
To Next Page
Loading...
Need help?
General
