HP MSR4080 Configuration Guide

131
Uptime: 00:11:18
# Display BSR information on Router E.
[RouterE] display pim bsr-info
Scope: non-scoped
State: Elected
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
Priority: 64
Hash mask length: 30
Uptime: 00:11:18
Candidate BSR address: 192.168.9.2
Priority: 64
Hash mask length: 30
# Display RP information on Router A.
[RouterA] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: 225.1.1.0/24
RP address Priority HoldTime Uptime Expires
192.168.9.2 192 180 00:51:45 00:02:22
Static RP information:
RP address ACL Mode Preferred
192.168.1.2 ---- pim-sm No
PIM-SM admin-scoped zone configuration example
Network requirements
As shown in Figure 46:
•
OSPF runs on the network.
•
VOD streams are sent to receiver hosts in multicast. The entire PIM-SM domain is divided into
admin-scoped zone 1, admin-scoped zone 2, and the global-scoped zone. Router B, Router C,
and Router D are ZBRs of the three zones, respectively.
•
Source 1 and Source 2 send different multicast data to multicast group 239.1.1.1. Host A
receives the multicast data only from Source 1, and Host B receives the multicast data only
from Source 2. Source 3 sends multicast data to multicast group 224.1.1.1. Host C is a
multicast receiver for multicast group 224.1.1.1.
•
GigabitEthernet 1/0/2 of Router B acts as a C-BSR and a C-RP for admin-scoped zone 1, and
GigabitEthernet 1/0/1 of Router D acts as a C-BSR and a C-RP for admin-scoped zone 2. Both
of the two interfaces are designated to multicast group range 239.0.0.0/8. GigabitEthernet 1/0/1
of Router F acts as a C-BSR and a C-RP for the global-scoped zone, and is designated to all
the multicast groups that are not in the range 239.0.0.0/8.
•
IGMPv2 runs between Router A, Router E, Router I, and the receivers that directly connect to
them, respectively.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English