IPv6 Diagnostic and Troubleshooting
Traceroute for IPv6
Syntax: traceroute6 < ipv6-address | hostname >
[minttl < 1-255 > [maxttl < 1-255 > [timeout < 1 - 60 >] [probes < 1-5 >] [source
<ipv6-addr | vlan-id>]
traceroute6 <link-local-address%vlan<vid> | hostname >
[minttl < 1-255 >] [maxttl < 1-255 >] [timeout < 1 - 60 >] [probes < 1-5 >]
[source <ipv6-addr | vlan-id>]
Displays the IPv6 address of each hop in the route to the
specified destination host device with the time (in
microseconds) required for a packet reply to be received from
each next-hop device.
<ipv6-address>: IPv6 address of a destination host device.
<link-local-address>%vlan<vlan-id>: IPv6 link-local address,
where %vlan<vlan-id> specifies the VLAN ID number.
<hostname>: Host name of an IPv6 host device configured on
an IPv6 DNS server.
minttl: Minimum number of hops allowed for each probe
packet sent along the route. Default: 1; Range: 1 - 255.
•If the minttl value is greater than the actual number of hops,
the traceroute output displays only the hops equal to or
greater than the configured minttl threshold value. The
hops below the threshold value are not displayed.
•If the minttl value is the same as the actual number of hops,
only the final hop is displayed in the command output.
•If the minttl value is less than the actual number of hops,
all hops to the destination host are displayed.
maxttl: Maximum number of hops allowed for each probe
packet sent along the route. Valid values: 1 - 255. Default: 30.
•If the maxttl value is less than the actual number of hops
required to reach the host, the traceroute output displays
only the IPv6 addresses of the hops detected by the
configured maxttl value.
timeout: Number of seconds within which a response is
required from the IPv6 device at each hop in the route to the
destination host before the traceroute operation times out.
Default: 5 seconds; Range: 1 - 60.
probes: Number of times a traceroute is performed to locate
the IPv6 device at any hop in the route to the specified host
before the operation times out. Default: 3; Range: 1 - 5.
source <ipv6-addr | vlan-id>: The source IP address or VLAN.
The source IP address must be owned by the router. If a VLAN
is specified, the IP address associated with the specified
VLAN is used
8-7
To Next Page
Loading...
Need help?
General