HP StorageWorks SN6000 User Manual

HP StorageWorks SN6000 Fibre Channel Switch QuickTools Switch Management User Guide 65
can be accomplished using HP Service Essentials Remote Support Pack as described in the HP
StorageWorks SN6000 Fibre Channel Switch Installation and Reference Guide.
Network properties
Use the Network Properties dialog boxes (Figure 32) to configure IP and DNS parameters.
1. Open the Network Properties dialog box, using one of the following methods:
• Open the faceplate display for the switch you are configuring, and then select Switch > Network
Properties, or
• Right-click a switch graphic in the faceplate display, and then select Network Properties from the
popup menu.
2. Click the IP tab to open the Network Properties IP dialog box or the DNS tab to open the Network
Properties DNS dialog box, as appropriate for your network setup.
3. Make the desired changes to the network properties.
4. After making changes, click OK to put the new values into effect.
Figure 32 Network Properties dialog boxes

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English