11 SERVICE WORK ON THE CHASSIS 68
11.40 Checking the frame
M01314-01
– Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
– Change the frame.
Info
Always replace a frame that has been damaged due to a mechan-
ical impact. Repair of the frame is not authorized by Husqvarna
Motorcycles.
11.41 Checking the swingarm
401520-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
– Change the swingarm.
Info
Always change a damaged swingarm. Repair of the swingarm is
not authorized by Husqvarna Motorcycles.
11.42 Checking the throttle cable routing
Preparatory work
(All TC models)
–
Turn handle
of the fuel tap to the OFF position.
(Figure F00230-10 p. 16)
(TX 300)
–
Turn handle
of the fuel tap to the OFF position.
(Figure F00231-10 p. 16)
– Remove the air filter box cover. ( p. 55)
– Remove the seat. ( p. 53)
– Remove the right side cover. ( p. 60)
– Remove the fuel tank. ( p. 61)
H01554-01
Main work
(TC 125)
– Check the throttle cable routing.
The throttle cable must be routed along the back of the handlebar, to the
right of the frame, above the fuel tank bracket, and to the carburetor. The
throttle cable must be secured behind the fuel tank contact area rubber
band.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
To Next Page
Loading...
Need help?
General
