2--2
6
Use and maintenance manual S20DSP
Cutting head
The oerating head is the element that performs the cut and is made up of a bow
made from a fusion of cast iron onto which the band, the band guide elements,
the band tensioning unit and the mechanical speed variator are mounted. The
operating head is restricted in its movements by the articulated joint on the
rotatng platform.
Motor
Blade guide heads
Belt tensioning wheel
T ransmission box
Drive pulley
Idle pulley
Rear flywheel
Speed variator
Cutting head beam
Front flywheel
Blade casing
To Next Page
Loading...
General