1--2
2
Use and maintenance manual S20DSP
Machine specification
Theanodisedaluminiumnameplateisrivetedonthesideofthemachine;the
same data are reproduced on the declaration of conformity included with this use
and maintenance manual.
bar bar
------ --
V
1PH
AVA
3PH
model
air pressure
data code
oil pressure
HYD--MECH
The Rock Solid Solution
When communicating with the Technical Service department, the model, serial
number and year of manufacture of the machine must be quoted.
CUTTING SPEEDS
Blade rotation speed mt/min
15 100
BAND SAW
Rated size mm
4500 x 27 x 0,9
Max/min blade length mm
4500 ± 40
Blade height mm
27
Blade width mm
0,9
Band saw tension Kg
1250
When choosing the cutting tool, if its dimensions do not correspond to those
included in the ”Ra ted size” section, check that the dimensions at least fall
within the admissible max/min specifications.
RATED ELECTRICAL POWER
Head spindle motor KW 1.,5
Electric coolant pump motor KW 0,1
M1 power pack motor (optional) KW
0,37
Max installed power KW 1,97
WORKING PRESSURE
Working pressure blade tensioning/detens ioning
Kg
1250/900
Head working pressure in the ascent phase (optional) Bar 20
Vice working pressure during opening/closure phase (AV ver-
sion)
Bar 6
N.B.
Attention
To Next Page
Loading...
General