2--3
7
Functional parts
Vice
The vice is the unit that clamps the workpiece during cutting. It consists of a vice
support, commonly known as a “lead nut”, fixed to the work table, and a lead
screw with a sliding support on which the mobile jaw is mounted. It can run
transversely with respect to the cutting surface, or lengthways, for opening and
closing, on the l inear guides and slides with recirculation of pre---loaded spheres.
Theviceismanuallynearedtothematerialtobecutusingahand---wheeland
blocking is performed using a hydraulic cylinder (in the AV version).
Slideway
Handwheel
Vice support (lead nut)
Control Panel
The control panel has a protection rating of IP 54 and contains the electronic
equipment. Access to the control panel is protected by a safety panel mounted on
hinges and fastened with screws, specially designed to prevent tampering. The
control panel swivels on two articulated joints so that it can be positioned by the
operator for greater ease---of---use and safety.
Control panel
Articulated joints
Control console
To Next Page
Loading...
General