3--4
14
Use and maintenance manual S20DSP
mm. 1500
FEED ROLLER TABLE
COLLECTION BASKET
Any maintenance work on the hydraulic or pneumatic systems must be
carried out only after the pressure in the system has been released.
The operator must not perform any risky operations or operations not
required for the machining operation under way (e.g. remove swarf or
metal shavings from the machine while cutting).
Remove equipment, tools or any other objects from the cutting zone;
always keep the working area as clean as possible.
Before starting an y cutting operat ions, ensure that the workpiece is
securely held in the vice and the machine has been set correctly. A
number of examples of how to cla mp different profiles correctly in our
machines are shown below.
Do not use the machine to cut pieces that exceed the capacity of the
machine as listed in the machine specifications.
Never move the machine while it is cutting.
Do not use blades of different sizes to those recommended in the
machine specifications.
When cutting very short pieces, make sure that they are not dragged
behind the support shoulder, where they could jam in the blade.
To Next Page
Loading...
General