DANGER
ELECTRICAL SHOCK CAN KILL
Remove all electrical connections to power supply before moving or positioning. Transporting unit
can cause personal injury and equipment damage.
The power supply can be moved by forklift but the forks must be long enough to extend the entire length of the
base. Take care when lifting so that the underside of the power supply is not damaged.
• Place the power supply in an area that is free of excessive moisture, has proper ventilation and is relatively
clean. Allow room at the sides and rear of the power supply for servicing.
• Cooling air is drawn in through the front panel and is exhausted through the rear of the unit by a cooling fan.
Do not place any filter device over the air intake locations, which reduces cooling efficiency and VOIDS
THE WARRANTY.
• Do not place the power supply on an incline greater than 10° to prevent it from toppling.
To Next Page
Loading...
Need help?
General
