5-31
05
Hood
Opening the hood
OAC3059017TU
1. Make sure the shift lever is in N
(Neutral, for Automated manual
transmission) or first gear or R
(Reverse, for Manual transmis-
sion) and set the parking brake.
2. Pull the release lever to unlatch the
hood. The hood should pop up
slightly.
OAC3059018TU
3. Go to the front of the vehicle, raise
the hood slightly, push the second-
ary latch up (1) inside of the hood
center and lift the hood (2).
OAC3059019TU
4. Pull out the stay-rod from the hood.
5. Hold the hood opened with the
stay rod.
Closing the hood
1. Before closing the hood, check the
following:
• All filler caps in engine compart-
ment must be correctly installed.
• Gloves, rags or any other com-
bustible material must be
removed from the engine com-
partment.
2. Return the support rod to its clip
location for preventing it from rat-
tling.
3. Lower the hood halfway (lifted
approximately 30cm from the
closed position) and push down to
securely lock in place. Then dou-
ble check to be sure the hood is
secure.
If the hood can be raised slightly, it
is not securely locked. Open it
again and close it with more force.
EXTERIOR FEATURES
To Next Page
Loading...
Need help?
General
