Hyundai i10 User Manual

7-11
07
The TPMS on this vehicle monitors
and compares the rolling radius and
rotational characteristics of each
wheel and tire while you are driving.
And it checks whether any tire is sig-
nificantly under-inflated.
You should reset the system by push-
ing the TPMS SET button according
the accurate procedure and store the
current tire pressure.
After that, if one or more tires are sig-
nificantly under-inflated, the low tire
pressure indicator illuminates and a
message is shown on the cluster.(if
equipped)
Also, if there is a malfunction with the
TPMS, the TPMS malfunction indica-
tor will illuminate.
TPMSresetprocedure
You should reset TPMS in below situ-
ations.
• Afterrepairingorreplacingtires(or
wheels)
• Afterrotatingtires
• Afteradjustingtirepressure
• Whenthelowtirepressureindica-
tor illuminates
• AfterreplacingsuspensionorABS
system
OAC3079026TU

Type A
OAC3079036TU

Type B
1. Park the vehicle on a level, firm
surface.
2. Inflate the tires to the proper pres-
sure as indicated on the vehicle’s
placard or tire inflation pressure
label located on the driver’s side
center pillar outer panel.
3. Starting the engine, press and hold
the TPMS SET button for about
three seconds to reset TPMS. The
reset process completes automati-
cally.
4. Then check that the low tire pres-
sure indicator turns off after blink-
ing for four seconds. In case of
supervision cluster, check that
“Tire pressures stored” message is
shown on the cluster.
5. After resetting the TPMS, drive the
vehicle for approximately 20 min-
utes to store the new tire pressure
in the system.

Hyundai i10 Specifications

General

Brand	Hyundai
Model	i10
Category	Automobile
Language	English