6. Are you finished with the repair?
v No: Continue with the next step.
v Yes: Replace the covers that were removed during this procedure and return to the procedure that
sent you here.
This
ends the procedure.
7.
To Install a disk unit using dedicated maintenance perform the following:
a. Power off the expansion tower. See Expansion unit power procedure.
b. Disconnect the power cord.
c. Put the disk unit part-way into the desired slot and rotate the handle of the disk unit towards you.
d. Push the disk unit completely into the slot and rotate the handle towards the disk unit to latch it into
the slot.
e. Replace the covers that were removed during this procedure and return to the procedure that sent
you here.
This ends the procedure.
FC 5075 - Display panel - NB1
For use by authorized service providers.
Use this procedure to remove or replace the display panel - NB1 on an FC 5075.
To remove or replace the display panel - NB1:
1. Open the front cover.
2. Power off the expansion unit. See Expansion unit power procedure.
3. Remove the front cover. See FC 5075 - Covers.
4. Remove the ac power cord on the frame you are working on.
5. Pull the locks on each side of the display panel.
6. Slide the display panel out approximately half way and remove the cables from the rear of the panel.
Analyze hardware problems 161
To Next Page
Loading...
Need help?
General