EasyManuals Logo
Home>IBM>Server>iSeries 800

IBM iSeries 800 User Manual

IBM iSeries 800
622 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
FC 5074, FC 5079, FC 5094, FC 5294, FC 9079, FC 9094 - Covers
For use by authorized service providers.
Use this procedure to remove or replace covers on the FC 5074, FC 5079, FC 5094, FC 5294, FC 9079,
FC 9094.
Note: The front and rear covers will swing open a little more than 90 degrees. This makes it possible to
replace all FRUs, without having to remove the covers.
v To open or remove the front cover, refer to Figure 1. Front cover - removal (See page ) below.
v To open or remove the rear cover, refer to Figure 2. Rear cover - removal (See page ) below.
Perform the following steps to open or remove each cover.
1. Unlock the cover (front only).
2. Open the cover by grasping its right side and pulling it towards you.
3. After opening the cover, press down on lever B, which is located inside along the top, left side of the
cover.
4. Tilt the top of the cover away from the tower, and lift the cover off.
This ends the procedure.
Figure 1. Front cover - removal
Figure 2. Rear cover - removal
Analyze hardware problems 177

Table of Contents

Other manuals for IBM iSeries 800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM iSeries 800 and is the answer not in the manual?

IBM iSeries 800 Specifications

General IconGeneral
BrandIBM
ModeliSeries 800
CategoryServer
LanguageEnglish

Related product manuals