TECHNICAL SPECIFICATION - Interfaces:
Ethernet port:
o Ethernet 100/1000Base-T - LAN/Network/Camera/RJ45 TDR test (1000Base-T), mRJ45 cable TDR test (1000Base-T)
RJ45 port:
o PoE IN - Pass-through PoE to the Ethernet port only no data pass through.
o Cable test - Cable test only Not Ethernet, no network connection.
Wi-Fi:
o Built in Wi-Fi 802.11b/g/n (2.4GHz only) up to speed 150Mb/s client to access the network for testing.
Coax port:
o BNC (f) video IN/HD Coax IN – Analog, TVI, CVI, AHD input
o BNC (f) video out – Analog video bar output
RS485 port: RS485 male “Phoenix” type connector for PTZ control and communications test
HDMI port:
o HDMI IN:
o HDMI supports: 720×480p /720×576p /1280×720p /1920×1080p /1024×768p/1280×1024p /1280×900p
/1440×900p video formats.
o Does not support HDCP copy protected video sources
o HDMI OUT: 1 channel HDMI output1280x720p, 1920x1080p user selectable.
Audio port:
o Audio IN: 3.5mm female socket for audio line in
o Audio Out: 3.5mm female socket for audio line out
DC output: 4.0x1.7mm female socket for 12V/2A DC output (center positive polarity)
USB port: Type A USB on 5V/2A DC power output only (No data transfer)
SD card slot: MicroSD card reader
DC input: 12V DC charge port with 5.5x2.1mm socket. Tester can operate and charge battery simultaneously.
LED Indication
Battery:
o ON - charging,
o OFF - fully charged when charge is ON or
o OFF – no charging when charge is OFF
o Flash – battery switch is OFF or no battery fitted (charge LED is ON)
Charge:
o ON - External DC 12V IN is plugged in
o OFF - External DC 12V IN is not plugged in
Tx & Rx:
Flash - Tx & Rx data for RS485
ON – Standby (both Tx & Rx ON)
To Next Page
Loading...
Need help?
General
