TECHNICAL SPECIFICATION – Electrical Test Functions
Power output:
o PoE: DC48V PoE/PoE+, 24W max
o DC 12V: DC12V/2A power for IP & analog cameras
o DC 5V: DC5V 2A power output via USB to charge portable devices
PoE & Voltage test
o PoE IN: voltage, power and pins used
o LAN/Network: voltage, power and pin used
o 12V DC IN: voltage, power consumed (operating and charging power consumption)
o 12V DC OUT: voltage, power consumed by attached device
o PoE link check: PD (Powered Device) port on cable Tracer/Remote Test’s PoE status of link and pairs used with LED
indicators for 12,36 or 45,78 pins.
Ethernet cable test:
o Twisted-pair test: Reports: – straight, crossed-pair, open, short and cross-over (MDI-MDIX) with Tracer/Remote.
o RJ45 TDR test: Length 180m (max), Resolution +/-1m; estimated attenuation (dB/100m or dB/100feet) with good, poor
and bad colour status; reflection %; impedance (Ω); delay skew (ns) (when connected to 1000Mb/s network device only),
pin number with pair length. Continuous and single test mode.
o Digital Tone generator: 4 different tone selections for cable tracing.
o Cable trace: Trace and locate cables with the included Tracer/Remote. Digital tone technology eliminates electrical
noise/hum associated with traditional analogue tracing probes. Eight (8) volume levels, headphone jack for use in noisy
environments, non-conductive tip to prevent short circuits and integrated LED flashlight. Requires 2 x 1.5V AAA (LR03)
batteries (not included).
To Next Page
Loading...
Need help?
General
