TECHNICAL SPECIFICATION – General Test Functions
IP Network test:
o Traffic monitoring: real-time upstream/downstream bandwidth histogram, tester IP address and link speed and full/half-
duplex condition.
o Ping: Local & destination IP address, packet size, number of ping tests and inter-packet delay.
o IP Scan: Scan for active devices within selected IP address range (subnet). Scan selected IP address for available
TCP/UDP port services.
o Port flash: Flash the link LED on of the switch to visually identify the port to which SecuriTEST IP is connected.
o DHCP Server: Fully configurable DHCP server to allow dynamically configured devices to operate when a network router
is not installed. Start/stop IP address range, lease time, connected client list display.
o Trace Route: Display IP address and delay time of up to 30 hops (routers) between device and target URL/IP address.
o Available IP: Create list of IP addresses and to scan for availability checking. Tester will scan each address and identify if
the address is available or in use by a network device. Use to find available IP addressed when before configuring a new
device with a static address.
o Network IP Scan: Cross-subnet IP scan on any linked network. Lists IP address of devices on multiple subnets compared
to IP Scan function which only lists devices on the same subnet as the tester.
Media playback/record applications:
o Video: RTSP player, Video player, VLC
o Audio: Audio recorder, Audio player
Image capture:
o Capture still image from connected camera (can be attached to test reports).
o Record video stream from connected camera.
o Capture current tester screen.
Audio:
o Audio IN: 1 channel audio signal input from camera to record, listen and play via media player or audio recorder/player;
2.5 mm (1/8”) connector.
o Audio OUT: 1 channel audio signal output to monitor audio from cameras with microphone; 2.5 mm (1/8”) connector.
o Speaker: Internal two speakers for system indicators and audio playback from cameras or other media files.
Test report (ONVIF only): PDF format with
o Company/customer project details,
o Tester information,
• Serial number/hardware version/firmware version/software version
• Date/time set
o Date/time of test conducted
o Camera manufacturer/model/name/software version/Date & time
o Camera network configuration,
o Link speed and duplex
o IP/gateway/DNS/MAC addresses, subnet mask
o Dynamic/static configuration
o Video stream information,
o Video resolution
o Frame rate
o Bit rate (kb/s)
o Encoding (CODEC) type
o Attach up to six (6) video still snapshot images,
o Operator’s notes
o Attach company/customer logo
Quick Access Shortcut menu: Single button access to eight (8) user-selectable functions
Remote view: View tester screen on other network device using RTSP (Real Time Streaming Protocol).
To Next Page
Loading...
Need help?
General
