Intel® Server Board S1200V3RP TPS BIOS Setup Interface
Revision 1.2
Screen Field Descriptions:
1. Set Throttling Mode
Option Values: Auto
Help Text:
Sets Thermal Throttling mode for memory, to control fans and DRAM power as needed
to control DIMM temperatures.
[Auto] – Auto Throttling Mode
[CLTM] - Closed Loop Thermal Management.
[OLTM] - Open Loop Thermal Management.
Closed Loop Thermal Management is supported only when ECC DIMM plugged. Open
Loop Thermal Management is not supported.
Comments: The Thermal Throttling Mode chosen reflects whether the DIMMs
have Temperature Sensors (TSOD), and whether the chassis is an Intel chassis for
which thermal data are available. Note that this is for thermal throttling only, independent
of any controls imposed for the purpose of power limiting.
· CLTM would be used with an OEM chassis and DIMMs with TSOD. The firmware
does not change the offset registers for closed loop during runtime, although the
Management Engine can do so.
· OLTM is intended for a system with UDIMMs which do not have TSOD. The thermal
control registers are configured during POST, and the firmware does not change
them.
Back to [System Acoustic and Performance Configuration] — [Screen Map]
2. Altitude
Option Values: 300m or less
301m-900m
901m-1500m
Higher than 1500m
Help Text:
[300m or less](980ft or less) Optimal near sea level.
[301m-900m](980ft-2950ft) Optimal performance setting at moderate elevation.
[901m-1500m](2950ft-4920ft) Optimal performance setting at high elevation.
To Next Page
Loading...
Need help?
General
