Remote Control
Copyright ©ITECH Electronic Co., Ltd. 112
the corresponding position on the rear panel of the instrument, the menu
item for changing the GPIB address appears in the System menu. The
specific steps are as follows:
1.
Ensure that the instrument's power switch is off, that is, the
instrument is in Power Off state.
2.
Insert the separately purchased GPIB interface card into the card slot
on the rear panel of the instrument.
3.
Connect the instrument with the computer via the GPIB cable. After
the con- nection is successful, turn on the power switch of the
instrument.
4.
Press the composite keys [Shift]+ （System） on the front
panel to en- ter the system menu.
5.
Select Communication and press [Enter].
6.
Select GPIB and press [Enter].
7.
Press the numeric keys to set the GPIB address and press [Enter].
9.5 RS-232 Interface (Optional)
The RS-232 interface shares the same communication card (IT-E177) with
the analog function.
Definition of RS-232 Pins
The definition of RS-232 pins are as follows.
When using the RS-232 interface for communication, connect the pin 1, pin
2, and pin 3 of the IT-E177 to the PC. The pin description is as follows:
1
TXD, transmit data
2
RXD, receive data
3
DGND, ground
To Next Page
Loading...
Need help?
General
