ITech IT7800 Series User Manual

System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 59
The procedures to set the menu item are as follows.
1. Press the General under the system menu.
2. Press the Up/Down key or turn the knob to select the Power-on setup and
press [Enter].
⚫ Reset: Default value, indicates when the instrument is powered on, the
instrument will initialize some parameter settings or state.
⚫ Last: Indicates when powered on, the instrument will remain the same
parameter settings and output status as last time you powered off the
instrument.
⚫ Last+Off: Indicates when powered on, the instrument will remain the same
settings as last time you powered off the instrument, but the output status
is Off.
Lock the Touch Screen
This parameter determines the state of the touch screen.
1. Press the General under the system menu.
2. Press the Up/Down key or turn the knob to select the Touch screen lock and
press [Enter].
⚫ On: enable the touch screen
⚫ Off: disable the touch screen
Set the Loop Speed
This item can control stability of the loop. When the connected load is capacitive
load or inductive load, select Slow; when the connected load is resistance, select
High.
Set the Knob Function
Set the knob setting function. If set to ON, the Knob setting will take effect
immediately. If set to OFF, press Enter to confirm the effect after the Knob setting
is completed.
Select Language
Users can select the instrument language type from the menu, supporting
Chinese and English.
Set the Soft Keyboard
The user can open the soft keyboard in the menu. When the parameter is set to
ON, the soft keyboard is enabled. And when setting parameters on the screen,
the soft keyboard appears. Convenient users directly touch screen to select the
number.
5.1.2 Set the communication interface
This menu item is used to set the communication information between
instrument and PC. The standard communication interfaces for IT7800 series
power supply are USB, LAN and CAN. You can also select the non-standard
interface GPIB or RS-232 based on personal requirement.
The user does not need to select the communication interface. The instrument
will automatically select the present communication mode according to the
communication interface accessed by the rear panel.The user only needs to set

ITech IT7800 Series Specifications

General

Brand	ITech
Model	IT7800 Series
Category	AC Power Distribution
Language	English