en-39
5 CONTROLS
5.2.H.31 WARNINGS ________________________________________________________
5.2.H.32 WARNING SLOPE ANGLE - ANGLE ALERT ______________________________
During work if the machine is driven on a slope greater than 17° the
screen will display this warning. This over rides all other information,
and will continue until the machine has been driven to an area with a
slope of less than 17°.
5.2.H.33 WARNING - OIL PRESSURE FAULT ____________________________________
When this screen is shown, the engine oil pressure has decreased
below the normal level. If this happens during operation, Stop the
engine and check the oil level. Top up if necessary. If the problem
persists consult your service dealer.
Press the select button to confirm the fault.
5.2.H.34 WARNING CLEAR RADIATOR SCREENS ________________________________
When this screen is shown, the engine temperature has risen above
normal levels.
Park the machine in a safe area disengage the cutting units, set
engine to idle to allow engine temperature to decrease prior to
switching off the engine.
Turn engine off, clean the radiator and screens of all grass and
debris.
Press the select button
to confirm the fault.
NOTICE
The number in the top right of the screen indicates the total number of current faults recorded.
If more than one fault, it will cycle all current faults.
To Next Page
Loading...
Need help?
General
