en-66
8 MAINTENANCE AND LUBRICATION
8.1 MAINTENANCE AND LUBRICATION CHARTS ______________________________
SERVICE INTERVAL CHART
Interval Item Section
First 50 hours
• Change the engine oil
• Change the engine oil filter
• Change the hydraulic filter elements
8.2
8.2
8.5
@
Every 8 hours or daily
• Check safety interlock system
• Check engine oil level
• Check engine coolant Level
• Check air filter service indicator
• Check the hydraulic fluid level
• Check the fuel level
• Check tyre pressure
• Check engine bay for dirt
• Clean radiator screens
6.2
8.2
8.3
8.6
8.8
8.1/8.18
Every 50 hours or weekly
• Check for loose components
• Check for hydraulic leaks
• Check tyre pressures
8.1
8.1
Every 100 hours
• Check alternator belt tension
• Clean the fuel filter
8.4
8.9
*1
@
Every 200 hours
• Change engine oil filter
• Check air intake
8.2
8.11 @
Every 400 hours • Change air filter 8.11
@
Every 500 hours
• Clean water jacket (radiator interior)
• Replace fan belt
8.4
Every year
• Replace fuel filter element
• Change air cleaner element
• Check battery condition
• Change hydraulic oil and filter
8.9
8.11
8.16
8.5/8.6
*2 @
Every 800 hours
• Check valve clearance
*3 @
Every 1500 hours
• Check fuel injection nozzle, injection pressure
*3 @
Every 3000 hours
• Check injection pump
*3 @
Every two years
• Replace radiator hoses and clamps
• Replace fuel pipes and clamps
• Change radiator coolant
• Replace air intake hoses
*3
*4
@
@
Items identified by @ are emission control parts. Kubota U.S.A. label these parts in compliance with EPA
non-road emission regulation.
The owner is responsible for the emissions of the vehicle and for the engine maintenance schedule.
Read the engine warranty statement.
After the first 50 hours of use, items identified must be completed.
*1 Clean the air filter every 25 hours in dirty environments
*2 After cleaning
*3 Contact your local Kubota dealer for this service.
*4 Replace any damaged or worn parts.
Lubricate these fittings every week
A = Front lift arm pivots C = Centre lift arm pivot D = Cutting unit mounting pivot
E = Bearing housing lubrication F = Roll lubrication
To Next Page
Loading...
Need help?
General
