en-46
6 OPERATION
6.1 DAILY INSPECTION____________________________________________________
1. Do a visual inspection of the vehicle and look for indication of wear, loose hardware. Check for any
components that are not included on the machine or damaged. Check for fuel and oil leaks to make
sure that all connections are tight. Make sure that all hoses and tubes are in good condition.
2. Check the fuel supply, radiator coolant level, crankcase oil level and air cleaner is clean. All fluids must
be at the full mark while the engine is cold.
3. Make sure all cutting units are adjusted to the same height of cut.
4. Check all tyres for the correct pressure.
5. Test the Operator Presence And Safety Interlock System.
CAUTION
The inspection must be done each day with the engine turned off and while all fluids are cold. Lower
the cutter equipment to the ground, engage the parking brake, stop the engine and remove the ignition
key.
To Next Page
Loading...
Need help?
General
