38
VTX A8 | Rigging Manual
8.10 ATTACHING THE ARRAY FRAME
Below are the steps for attaching a VTX A8 AF to a stack of four VTX A8 enclosures.
STEPS:
• For easiest attachment, separate the Array Frame from the Extension Bar.
• Ensure that the top cabinet is set to a 4-degree angle and that the Array Frame is properly oriented. Lift the frame over the top
A8 cabinet on the cart and rest it on the four quick release pin attachment points on the top cabinet.
• Remove the quick release pins from their storage positions and place each into its respective attachment position. The quick
release pins should be attached from the inside of the Array Frame.
• Once the Array Frame is secured to the top of the cabinet, the Extension Bar can be attached. Confirm correct orientation by
consulting LAC and ensure that the correct A, B, or C position is attached using both of the included large-gauge quick release
pins.
1
2
3
4
Note: The quick release pins connecting the array frame to the first A8 or B18 cabinet are mounted from the inside of the frame as shown
above. The QRP lanyards are not long enough to reach the outside positions.
3
2
4
Pin Position: 4°
To Next Page
Loading...
Need help?
General
