66
VTX A8 | Rigging Manual
13.3 ATTACHING THE MINI FRAME TO A8
Here are the steps to attach a Mini Frame to an A8 cabinet:
STEPS:
• Check that the top cabinet angle is at the 4º setting.
• Attach the two side arms to the top A8 cabinet using the four Mini Frame quick release pins, installed from the outside of the
Mini Frame.
• With the side arms secured, attach the spreader bar to the side arms using the two spreader bar quick release pins.
1
2
3
CAUTION: Always be certain that the two spreader bar quick release pins are fully seated and engaged before suspending
an array. Make sure to fully insert the QRPs into the spreader bar and check for correct installation by pulling on them. The
QRPs should be fully seated with minimal movement.
To Next Page
Loading...
Need help?
General
