63
VTX A8 | Rigging Manual
12.7 SUSPENSION BAR AND MIXED ARRAYS
The VTX A8 SB can used as a pull back for mixed arrays, but not in place of an Array Frame at the top of the array. In mixed array situa-
tions, an Array Frame is always used at the top to provide the structural rigidity needed for mechanical safety. Note that the Suspension
Bar can be used at the top of a B18-only array. Details on the Suspension Bar and B18 usage are available in the B18 Rigging Manual.
All mixed array configurations should be checked with LAC-3 for mechanical safety.
CAUTION: The VTX A8 SB Suspension Bar should never be used at the top of an array when VTX A8 and VTX B18 products
are used as part of the same array. Always check with LAC-3 for mechanical safety.
TIP: The VTX A8 SB Suspension Bar can be used at the top of B18-only arrays as the main suspension frame. Refer to the
VTX B18 Rigging Manual for suspension bar usage examples.
To Next Page
Loading...
Need help?
General
