73
VTX A8 | Rigging Manual
14.5 ASSEMBLING GROUND-STACKED ARRAYS
The Base Plate attaches to any JBL VTX subwoofer with an M20 pole mount adapter/plate. Before attaching the Base Plate, assemble
the subwoofer array/stack and place it with the desired location and position. The Base Plate connects to the subwoofers using the
included M20 knob. A8 cabinets connect to the Base Plate using the cabinet’s quick release pins. Follow the instructions below to as-
semble the A8 ground stacked array. The same steps are used regardless of the subwoofer type.
STEPS:
• Place the Base Plate onto the top subwoofer in the array.
• Use the included M20 knob to secure the Base Plate onto the subwoofer.
• If B18s are used, make sure all are pinned together, and that either the stabilization feet or a VT cart is used at the bottom.
1
2
3
2
1
3
CAUTION: Safe limits for ground-stacked arrays always assume that the stacking surface (floor and or stage) is flat.
Do not deploy ground-stacked arrays on non-flat surfaces to avoid tipping hazards.
To Next Page
Loading...
Need help?
General
