38 - 4
Service Procedures
Seat Arms Control Lever - Adjustment
In some instances it may be necessary to adjust the
operation of the arms raise/lower control lever 1.
When the button 2 is depressed upwards fully, the arms are
released for raise/lower. If the arms are not released, or
release but re-lock when the button is fully depressed,
adjust the control lever as follows:
If the arms do not release
1 Slacken lock nut 3 and screw the stop bolt 4 out (anti-
clockwise). Test the operation of the control lever and
then tignten the lock nut 3.
If the arms release but re-lock
1 Slacken lock nut 3 and screw the stop bolt 4 in
(clockwise). Test the operation of the control lever and
then tighten the lock nut 3.
Section D Controls
9803/3280
Section D
38 - 4
Issue 1
Precision Control (Servo)
To Next Page
Loading...
Need help?
General
