Pressure Testing the 2/4WD Clutch
1 Assemble the 2/4 wheel drive clutch, as described in
‘Assembly’.
2 Check the clutch pack end float and adjust as required
(see Assembly).
3 Using special tool 993/59300, insert the adaptor A into
the oil gallery in the end of the 2/4 wheel drive clutch
shaft as shown. Hold the adaptor in position with
clamp B.
4 Use a hand pump to pressurise the clutch assembly
until gear, item 5 can be turned by hand. Note the
pressure gauge reading - DO NOT EXCEED 200 lb/in
2
(13.8 bar).
5 If the pressure gauge reading is between 125 - 135
lbf/in
2
(8.6 - 9.3 bar) then the clutch is operating
correctly and can be fitted in the transmission.
6 If however the pressure gauge reading is above 135
lbf/in
2
(9.3 bar) then check the clutch for assembly
defects, especially the clutch pack end float (the shim
may not be to the correct thickness). -test after
checking for (and rectifying) assembly defects.
116 - 1
Section F Transmission
9803/3280
Section F
116 - 1
Issue 1
Synchro Shuttle Gearbox
B
A
S185720
To Next Page
Loading...
Need help?
General
