3 - 1
Pre-start Cold Checks Operation 10 50 †100 500 1000 2000
Service Points and Fluid Levels Hr Hr Hr Hr Hr Hr
ENGINE
Oil level - Check
!!
Oil and Filter ∀ - Change
!! !!
Air Cleaner Outer Element # - Change
!!
Air Cleaner Inner Element - Change
!
Fuel Filter - Change
!! !!
Fuel Filter - Drain
!
Coolant Quality/Level - Check
!!! ! ! !
Fuel Sedimenter - Drain and Clean
!! ! ! !
Fan Belt Tension/Condition - Check
!! ! ! !
Valve Clearances and Clean Breather Gauze (if fitted) ∃ - Check and Adjust
!
Engine Mounting Bolts for Tightness ∃ - Check
!! !!
Radiator - Clean
!!!
All Hoses - Condition - Check
!! !!
TRANSMISSION, AXLES
AND STEERING
Transmission Oil Level - Check
!!! !
Transmission Oil % - Change
!!
Transmission Filter - Change
!! !!
Axle Oil Level (incl. Hubs when applicable) & - Check
!!
Axle Oil (incl. Hubs when applicable) ∋ - Change
!!
Axle Oil - Limited Slip Differential - Change
!!!
Tyre Pressures/Condition - Check
!!! ! ! !
Front Hub Bearings ∃ - Check
!! !!
Transmission Strainer - Clean
!!
Drive Shafts - Security/Grease
!! !!
Steer Axle Movement/Shimming ∃ - Check
!! !!
Steer Axle Pivots and Linkages ( - Grease
!! !!
Front Axle Main Pivot - Grease
!!! ! ! !
HYDRAULICS
Oil Level ) - Check
!!! ! !
Oil ∃ - Sample/Change
!
Oil Filter - Change
!! !!
Rams - Chrome Condition - Check
!! !!
Section 3 Routine Maintenance
9803/3280
Section 3
3 - 1
Issue 1
Service Schedules
A badly maintained machine is a danger to the operator and
the people working around him. Make sure that the regular
maintenance and lubrication jobs listed in the service
schedules are done to keep the machine in a safe and
efficient working condition.
! WARNING
Maintenance
Maintenance must be done by suitably qualified
personnel. Before attempting any maintenance work,
make sure the machine is safe. Park on level ground. If it
is necessary to work with the loader arms raised, then
the loader arm safety strut must be fitted as shown in
Loader Arm Safety Strut in MAINTENANCE section.
2-3-1-1
Apart from the daily jobs, the schedules are based on
machine running hours. Keep a regular check on the
hourmeter readings to correctly gauge service intervals. Do
not use a machine which is due for a service. Make sure
any defects found during the regular maintenance checks
are rectified immediately.
Calendar equivalents:
10 Hours = Daily
50 Hours = Weekly
500 Hours = Six Months
1000 Hours = Yearly
2000 Hours = 2 Years
To Next Page
Loading...
Need help?
General
