Memo :
0
When
[Main Menu] B [A/V Set] B [Audio Set] B
[Limiter] is set to “Off” while in the automatic
adjustment mode, the limiter operates at
-6 dBFS.
0
When [A/V
Set] B [Audio Set] B [Audio On FULL
AUTO] is set to “SW Set”, you can switch the
audio recording mode with the [CH1/CH2
AUTO/MANUAL] selection switch on the
camera recorder even if the [FULL AUTO]
button is set to “ON”.
(A P
112 [ Audio On FULL AUTO ] )
Setting the Audio recording Level in the
Main Menu
* Enabled only when the handle unit is not
attached.
1
Select [Main Menu] B [A/V Set] B [Audio
Set
] B [Audio Level].
0
The
[Audio Level] screen appears.
.
* The contents displayed on the screen vary
depending on the various settings.
2
Select “Auto” or “Manual” using the
[LOLUX/3]
button.
0
If “Auto”
is selected, the audio recording level
will be automatically adjusted.
0
If “Manual
” is selected, the volume appears
on the screen. Use the cross-shaped button
(H I) to adjust the volume.
Memo :
0
When
the [FULL AUTO] button is set to “On” and
[Audio On FULL AUTO] in the menu is set to
“Auto”, the audio recording level cannot be
selected.
0
If both CH1 and CH2 are set to the built-in
microphone or to AUX, settings for CH2 will not
be
displayed, and the settings for CH1 will apply
to CH2.
Monitoring Audio Sound
During Recording Using a
Headphone
You can check the recorded audio using
headphone.
.
1
Connect the headphone.
2
Select [Main Menu] B [
A/V Set] B [Audio
Set] B [Monitor].
3
Adjust the monitor volume using the J / K
volume buttons on the side of the camera
recorder.
Memo :
0
There is no audio output from the monitor
speaker in Camera mode.
0
Warning tone is output when there is an
abnormality
in the camera recorder or when the
battery is low.
(A P174 [Warning Tone] )
0
You can set the volume of the warning tone in
[Main Menu] B [A/V Set] B [Audio Set] B [Alarm
Level]. (“Off”/“Low”/“High”)
(A P
112 [ Alarm Level ] )
Audio Recording
67
Shooting
To Next Page
Loading...
Need help?
General
