Disassembly 5-3
Static sensitive devices
CMOS devices operate at very high impedance levels. Therefore, any static that builds up on
you or your clothing may be sufficient to destroy these devices if they are not handled properly.
Use the following precautions to avoid damaging them:
CAUTION Many CMOS devices are installed in the Model 2700. Handle all semicon-
ductor devices as being static sensitive.
• Transport and handle ICs only in containers specially designed to prevent static build-
up. Typically, you will receive these parts in anti-static containers made of plastic or
foam. Keep these devices in their original containers until ready for installation.
• Remove the devices from their protective containers only at a properly grounded work
station. Also, ground yourself with a suitable wrist strap.
• Handle the devices only by the body; do not touch the pins.
• Ground any printed circuit board into which a semiconductor device is to be inserted to
the bench or table.
• Use only anti-static type desoldering tools.
• Use only grounded-tip soldering irons.
• Once the device is installed in the PC board, it is normally adequately protected, and
you can handle the boards normally.
Assembly drawings
Use the following assembly drawings to assist you as you disassemble and reassemble the
Model 2700. Also, refer to these drawings for information about the Keithley part numbers of
most mechanical parts in the unit. The drawings are located at the end of this section of the
manual.
• Front Panel Assembly — 2700-040
• Card Cage/Power Module Assembly — 2700-050
• Power Module/Transformer/Chassis Assembly — 2700-051
• Front Panel/Card Cage/Chassis Assembly — 2700-052
• Chassis Assembly — 2700-053, 2700-054
• Final Inspection — 2700-080
To Next Page
Loading...
Need help?
General
