Model 6220/6221 User’s Manual Getting Started 1-19
Return to Section 1 topics
Select power-on setup
Power-on to PRESET defaults:
Press SETUP > Select POWER ON > Select PRESET
Power-on to *RST defaults:
Press SETUP > Select POWER ON > Select *RST
Power-on to user setup:
Press SETUP > Select POWER ON > Select USER SETUP NUMBER >
Set memory location (0 to 4) > Press ENTER
Remote programming
SCPI programming
SCPI programming information is integrated with front panel operation throughout
this manual. SCPI commands are listed in tables and additional information that
pertains exclusively to remote operation is provided after each table.
Optional command words
In order to be in conformance with the IEEE-488.2 and SCPI standards, the
Model 622x accepts optional command words. Any command word that is enclosed
in brackets ([]) is optional and need not be included in the program message.
Query commands
Most command words have a query form. A query command is identified by the
question mark (?) that follows the command word. A query command requests
(queries) the programmed status of that command. When a query command is
sent and the Model 622x is addressed to talk, the response message is sent to
the computer.
SYSTem:POSetup <name> ‘
‘
‘
Select power-on setup.
<name> = RST, PRESet, SAV0, SAV1, SAV2, SAV3, or
SAV4.
NOTE Except for Section 14 in the Reference Manual, most
SCPI tables in this manual are abridged to some degree.
That is, they may NOT include optional command words
and most query commands. Optional command words
and query commands are summarized as follows.
To Next Page
Loading...
Need help?
General