27
4
4
Features of your vehicle Driver Position Memory System
Storing memory positions
1. The ignition switch or ENGINE START/
STOP button is in the ON position.
2. Adjust the driver's seat position, out
-
side rear view mirror position and
instrument panel illumination intensity
to the desired position.
3. Press the SET button. The system will
beep once and notify you "Press but
-
ton to save settings"on the LCD dis
-
play.
4. Press one of the memory buttons (1 or
2) within 4 seconds. The system will
beep twice when the memory has
been successfully stored.
5. "Settings 1 (or 2) saved" will appear on
the LCD display.
Recalling memory positions
1. The ignition switch or ENGINE START/
STOP button is in the ON position.
2. Press the desired memory button (1 or
2). The system will beep once, and
then the driver's seat position, outside
rear view mirror position, instrument
panel illumination intensity and head-
up display height/brightness will auto
-
matically adjust to the stored posi
-
tions.
3. "Settings 1 (or 2) applied" will appear
on the LCD display.
僅 While recalling the "1" memory posi
-
tion, pressing the SET or 1 button tem
-
porarily stops the adjustment of the
recalled memory position. Pressing
the 2 button recalls the "2" memory
position.
僅 While recalling the "2" memory posi
-
tion, pressing the SET or 2 button
temporarily stops the adjustment of
the recalled memory position. Press
-
ing the 1 button recalls the "1" memory
position.
僅 While recalling the stored positions,
pressing one of the control buttons
for the driver's seat, outside rear view
mirror, or instrument panel illumina
-
tion will cause the movement of that
component to stop and move in the
direction that the control button is
pressed.
Driver position memory system
reset
If the Driver position memory system
does not work properly, initialize the sys
-
tem as follows.
How to initialize:
1. Stop the vehicle and open the driver's
door with the ignition switch or
ENGINE START/STOP button in the
ON position and the vehicle shifted to
P (Park).
2. Pull the driver's seat forward as far as
possible and have the seatback
upright as much as possible using the
driver's seat forward/backward
adjustment and seatback angle
(recline) switches.
3. Push the SET button and seat forward
movement switch for 2 seconds
simultaneously.
Initialization in the process:
1. Initialization begins as the alarm
sounds.
2. The seat and seatback will automati
-
cally move backwards. The alarm
sound will continue while the system
is in operation.
3. Initialization will be complete after the
seat and seatback move to the center
with an alarm sound. If, however,
cases as follows occur, the initializa
-
tion process will come to a stop and
the alarm sound will stop as well.
To Next Page
Loading...
Need help?
General
