Features of your vehicle
1264
Wipers and washers
僅 OFF - Off
E: Wash with brief wipes (Rear/Push
lever away from you)
Windshield wipers
Operate as follows when the ignition
switch or ENGINE START/STOP button is
ON.
僅 MIST: For a single wiping cycle, move
the lever to this position and release it.
The wipers will operate continuously if
the lever is held in this position.
僅 OFF: Wiper is not in operation
僅 INT: Wiper operates intermittently at
the same wiping intervals. Use this
mode in light rain or mist. To vary the
speed setting, turn the speed control
knob.
僅LO: Normal wiper speed
僅 HI: Fast wiper speed
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or until
the snow and/or ice is removed before
using the windshield wipers to ensure
proper operation. If you do not remove
the snow and/or ice before using the
wiper and washer, it may damage the
wiper and washer system.
If you operate the wipers while driving
on snowy roads, the wipers may stop
due to snow buildup on your windshield.
This is normal and not a failure because
it is one of our safety features to prevent
vehicle accidents and wiper damage
from overloading the wiper motor. If the
wipers stop, remove snow accumulated
on the top or bottom of windshield
before using them.
Operating windshield washers
1. Move the wiper speed control switch
to the OFF position.
2. Pull the lever gently toward you to
spray washer fluid on the windshield
and to run the wipers 1 ~ 3 cycles. Use
this function when the windshield is
dirty. The spray and wiper operation
will continue until you release the
lever.
If the washer does not work, check the
washer fluid level. If the fluid level is not
sufficient, you will need to add appropri
-
ate non-abrasive windshield washer
fluid to the washer reservoir.
The reservoir filler neck is located in the
front of the engine compartment on the
passenger side.
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
To Next Page
Loading...
Need help?
General
