105
4
4
Features of your vehicle LCD displays
Service mode
This mode reminds you of scheduled
maintenance information.
Service Interval
It calculates and displays when you need
a scheduled maintenance service (mile
-
age or days).
If the remaining mileage or time reaches
1,500 km (900 miles) or 30 days, "Ser
-
vice interval" message is displayed for
several seconds each time you set the
ignition switch or ENGINE START/STOP
Button to the ON position.
Service required
If you do not have your vehicle serviced
according to the already inputted ser
-
vice interval, "Service required" message
is displayed for several seconds each
time you set the ignition switch or
ENGINE START/STOP Button to the ON
position.
To reset the service interval to the mile
-
age and days you inputted before:
僅 Press the OK button (Reset) for more
than 1 second.
If any of the following conditions occurs,
the mileage and days may be incorrect.
僅 The battery cable is disconnected.
僅 The battery is discharged.
Driving info display
At the end of each driving cycle, the
Driving Info message is displayed.
This display shows the trip distance, the
average fuel efficiency, and the instant
fuel efficiency (or the total driving time).
This information is displayed for a few
seconds when you turn off the vehicle,
and then goes off automatically. The
information is calculated for each time
the vehicle is turned on.
僅 If sunroof open warning is displayed
in the cluster, the Driving Information
message may not be displayed.
To Next Page
Loading...
Need help?
General
