Driver assistance system
626
Intelligent Speed Limit Assist (ISLA)
Changing set speed
If the speed limit of the road changes
during the operation of Manual Speed
Limit Assist or Smart Cruise Control, an
arrow in the direction of up or down is
displayed to inform the driver that the
set speed needs to be changed. At this
time, the driver can change the set
speed according to the speed limit by
using the + or – switch on the steering
wheel.
僅 If the Offset is set over '0', the set
speed will change to a higher speed
than the speed limit of the road. If you
want to drive below the speed limit,
set the Offset under '0' or use the –
switch on the steering wheel to lower
the set speed.
僅 Even after changing the set speed
according to the speed limit of the
road, the vehicle can still be driven
over the speed limit. If necessary,
depress the brake pedal to reduce
your driving speed.
僅 If the speed limit of the road is under
30 km/h (20 mph), the set speed
change function will not work.
僅 Intelligent Speed Limit Assist oper
-
ates using the speed unit in the instru
-
ment cluster set by the driver. If the
speed unit is set to a unit other than
the speed unit used in your country,
Intelligent Speed Limit Assist may not
operate properly.
For more details on operation of Smart
Cruise Control, refer to "Smart Cruise
Control (SCC) (if equipped)" on page 6-
76.
Intelligent Speed Limit Assist
malfunction and limitations
Intelligent Speed Limit Assist
malfunction
When Intelligent Speed Limit Assist is not
working properly, the 'Check speed limit
system' warning message will appear on
To Next Page
Loading...
Need help?
General
