8.6
Section 8
Disassembly
8. Remove the insert from the intake port (some
models), if separate from the heat deflector. See
Figure 8-20.
Figure 8-22. Removing Ignition Module.
Remove Grass Screen, Fan, and Flywheel
1. Unsnap the grass screen from the cooling fan. See
Figure 8-23.
Insert
Figure 8-20. Removing Insert (Some Models).
Remove Ignition Module
1. Disconnect the kill lead from the ignition module.
2. Rotate the flywheel magnet away from the
module.
3. Remove the RFI sheathed spark plug lead with
from retaining clip, if so equipped. See Figure
8-21.
Figure 8-21. Removing Lead from Clip (RFI
Suppression Equipped Units.
4. Remove the two hex flange screws and the
ignition module. See Figure 8-22.
Figure 8-23. Removing Grass Screen.
NOTE: Always use a flywheel strap wrench or
flywheel holding tool (see Section 2) to hold
the flywheel when loosening or tightening
the flywheel and fan retaining fasteners. Do
not use any type of bar or wedge between
the fins of the cooling fan, as the fins could
become cracked or damaged.
2. Remove the retaining screw, washer and the fan
mounting plate, securing the fan and flywheel to
the cranksha. See Figure 8-24.
To Next Page
Loading...
Need help?
General