bizhub C3850/C3350 6-7
6.2 Operations required to use this function (for Administrators)
6
12 Restart this machine.
NOTICE
When restarting this machine, turn the Power Switch off and on again after 10 or more seconds have
elapsed. Not doing so may result in an operation failure.
13 Connect the authentication unit to the machine's USB Port.
NOTICE
When connecting or disconnecting the USB cable, hold the plug. Otherwise, the machine may be dam-
aged or a failure may occur.
Associating user information with the card ID
If user information is not associated with the card ID or when the registered card ID is changed, you can as-
sociate the user information with the card ID using the Control Panel.
1 In the Control Panel, tap [Utility] - [Administrator Settings] - [User Authentication/Account Track] -
[Card Authentication].
2 Specify a user for whom you want to register the card ID, then tap [OK].
3 Tap [Edit].
% Tapping [Delete] to delete the registered card ID.
4 Pass the IC card over or place it on the authentication unit, then tap [OK].
NOTICE
During scanning, do not leave the IC card within 1-9/16 inches (40 mm) from the card reader.
5 Tap [Close].
To Next Page
Loading...
Need help?
General
