Introduction
9
Pos: 8.12.1 /Übersc hriften/Übersc hriften 2/A-E /B/Bestimmungsg emäße Ver wendung @ 10 3\mod_13321 69199326_78.d ocx @ 940071 @ 2 @ 1
Ver
3.5 Intended use
Pos: 8.12.2 /BA/ Einleitung/Besti mmungsgemäßer Gebrauch/ EasyCut/Bestim mungsgemäßer Gebrauch (Ei nzahl) @ 3\ mod_12045483 57809_78.doc x @ 70671 @ @ 1
The disc mower is built exclusively for customary use in agricultural work (intended use).
Pos: 8.12.3 /BA/ Einleitung/Besti mmungsgemäßer Gebrauch/Nic ht bestimm ungsgemäß @ 103\mod_133 2171672294_78 .docx @ 9402 72 @ @ 1
Unauthorised modifications to the machine may have a negative effect on the machine
characteristics or safe and reliable use of the machine or may interfere with proper operation.
Unauthorised modifications shall therefore release the manufacturer of any liability for
consequential damage.
Pos: 8.13 /Übersc hriften/Übersc hriften 2/K-O/NN utzungsdauer der Maschin e @ 318\mod _1423658430909 _78.docx @ 2465744 @ 2 @ 1
3.6 Service life of the machine
Pos: 8.14 /BA/Einl eitung/Nutzu ngsdauer der Masc hine_Text @ 318\mod_ 1423556613022_ 78.docx @ 2 463145 @ @ 1
– The service life of this machine strongly depends on proper use and maintenance as well as
the operating conditions.
– Permanent operational readiness as well as long service life of the machine can be
achieved by observing the instructions and notes of these operating instructions.
– After each season of use, the machine must be checked thoroughly for wear and other
damage.
– Damaged and worn parts must be replaced before placing the machine into service again.
– After the machine has been used for five years, carry out full technical inspection of the
machine. According to the results of this inspection, a decision concerning the possibility of
reuse of the machine should be taken.
– Theoretically, the service life of this machine is unlimited as all worn or damaged parts can
be replaced.
Pos: 8.15 /BA/Einl eitung/Technis che Daten/Tech nische Daten mit 2. Übersc hrift @ 0\mod_ 11955663748 65_78.docx @ 59 4 @ 2 @ 1
3.7 Technical data
All information, illustrations and technical data in these operating instructions correspond to the
latest state at the time of publication. We reserve the right to make design changes at any time
and without notification of reasons.
Pos: 8.16 /BA/Einl eitung/Technis che Daten/AM-M ähwer ke/AM 203S/243S/ 283S/AM 323 S @ 69\mod_ 1305030094793_ 78.docx @ 631 005 @ @ 1
wa
Hydraulic connections
required
*) EW= Single-action control unit
Pos: 9 /Layout Mo dule /---------------Seitenumbruch---------------- @ 0\mod_1196175311 226_0.docx @ 4165 @ @ 1