18 EXHAUST CONTROL
130
18.1 Programming the end positions of the exhaust control
Info
If work has been carried out on the exhaust control, the end positions must be reprogrammed.
Condition
The engine is off.
Preparatory work
– Remove the seat. ( p. 70)
D08200-10
Main work
–
Pull diagnostics connector
1
off the holder.
D08201-10
–
Move throttle grip
2
to where it is half open and hold in posi-
tion.
D08202-10
–
Plug wake-up connector
A
into diagnostics connector
1
.
Info
Wake-up connector
A
is in the motorcycle's separate
enclosure.
– Wait for at least five seconds.
The end positions of the exhaust control are read. The pro-
cedure is clearly audible.
The combination instrument lighting is activated, the
combination switch lights up green.
– Release the fixing from the throttle grip.
The end positions of the exhaust control are programmed.
– Wait until you can no longer hear the exhaust control engine
operating.
–
Disconnect wake-up connector
A
from diagnostics connec-
tor
1
.
To Next Page
Loading...
Need help?
General
