EasyManuals Logo

KTM 350 XCF-W USA User Manual

KTM 350 XCF-W USA
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
8 PREPARING FOR USE 39
Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
If you carry any baggage, make sure it is fixed firmly as close as possible to the center of the vehicle and ensure even weight dis-
tribution between the front and rear wheels.
Info
Motorcycles react sensitively to any changes of weight distribution.
Do not exceed the overall maximum permitted weight and the axle loads.
Guideline
Maximum permissible overall weight 335 kg (739 lb.)
Maximum permissible front axle load 145 kg (320 lb.)
Maximum permissible rear axle load 190 kg (419 lb.)
Run in the engine. ( p. 39)
8.2 Running-in the engine
During the running-in phase, do not exceed the specified engine speed and engine performance.
Guideline
Maximum engine speed
During the first operating hour 7,000 rpm
Maximum engine performance
During the first 3 operating hours 75 %
Avoid fully opening the throttle!
8.3 Preparing the vehicle for difficult riding conditions
Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can lead to considerably more
rapid wear of components such as the drive train, brake system, or suspension components. For this reason, it may be neces-
sary to inspect or replace parts before the next scheduled service.
KTM recommends that you use the specified engine oil for difficult riding conditions and to increase performance.
Engine oil (SAE 10W/60) (00062010035) ( p. 126)
Clean the air filter and air filter box. x ( p. 69)
Info
Check the air filter approx. every 30 minutes.
Seal the air filter box. x ( p. 70)
Additionally secure the rubber grip. ( p. 78)
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion or damage is found:
Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
Rides on dry sand. ( p. 40)
Rides on wet sand. ( p. 40)
Rides on wet and muddy surfaces. ( p. 41)
Rides at high temperature and slow speed. ( p. 41)
Rides at low low temperature or in snow. ( p. 41)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 350 XCF-W USA and is the answer not in the manual?

KTM 350 XCF-W USA Specifications

General IconGeneral
BrandKTM
Model350 XCF-W USA
CategoryMotorcycle
LanguageEnglish

Related product manuals