30/ASSEMBLING ENGINE 101
Installing the balancer shaft
200134-11
ಥ Check parts for damage and wear. Replace damaged or worn parts.
ಥ Slide balancer shaft
 into the bearing seats. Align the marking on balance
weightîš‘
 with the marking on primary pinion.
Installing the outer clutch hub
200097-10
ಥ Check parts for damage and wear. Replace damaged or worn parts.
ಥ Slide the outer clutch hub onto the main shaft. Turn oil pump gear
 and kick-
starter gearîš‘
 until the gearing of the outer clutch hub engages.
200096-12
ಥ Slide on washer and inner clutch hub.
200095-01
ಥ Position the new lock washer and mount nut. Fix the inner clutch hub using the
special tool and tighten the nut.
Specification
Nut, inner clutch hub M18x1,5 80îš‘Nm
(59.01îš‘lbfîš‘ft)
Clutch holder (51129003000) ( P. 178)
ಥ Secure the nut with lock washer.
ಥ Insert the pressure piece.
Installing the primary gear nut
200099-11
ಥ Block the outer clutch hub and primary gear using special tool.
Gear segment (80029004000) ( P. 183)
ಥ Mount and tighten the nut.
Specification
Nut, primary gear M20LHx1,5 150îš‘Nm
(110.64îš‘lbfîš‘ft)
Loctite
®
648â„¢
To Next Page
Loading...
Need help?
General
